GB 2 DEFINITION OF USE This washing machine is exclusively destined to wash machine washable laundry in quantities which are usual for private households. •Observe the instructions given in these Instructions for Use and the Programme Chart when using the washing machine.Keep these Instructions for Use and the Programme Chart; if you pass on the washing machine to another person, also give him/her Instructions for Use and Programme Chart. BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a.Cut and remove the shrink-wrap. B.Remove the top protection and the protective corners.

Remove the bottom protection by tilting and turning the washing machine on one rear bottom corner. Make sure that the black plastic part of the bottom protection (if available on the model) remains in the packing and not in the machine bottom. This is important, as otherwise the plastic part could damage the washing machine during operation. D.Open the lid by pressing it slightly down while raising the handle. Remove the polystyrene cushion (depending on model).

Whirlpool washing machines awe 6416 related questions and answers. Not able to supply any type of manual, installation instructions, electrical or schematic.

E.Remove the blue protective film from the panel (depending on model). After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine.

Contact After-Sales Service or your local retailer. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children; they are potentially dangerous. If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating.

Roberta flack best of rar. Remove the transport bracket The washing machine is fitted with transport screws and a transport bracket to prevent damage during transport. Before using the washing machine you must remove the transport bracket (see “Installation”/“Removal of transport bracket”). Install the washing machine Place the washing machine on a flat and stable floor surface.  Adjust the feet to ensure that the machine is stable and level (see “Installation”/“Adjust the feet”).

In case of wooden or so-called “floating floors” (for instance certain parquet or laminate floors), place the appliance on a 40 x 60 cm sheet of plywood at least 3 cm in thickness which is secured to the floor. Make sure that the ventilation openings in the base of your washing machine (if available on your model) are not obstructed by a carpet or other material. Water supply Connect the water supply inlet hose in accordance with the regulations of your local water company (see “Installation”/“Connect the water inlet hose”).

Water supply: Cold water only Tap: 3/4” threaded hose connection Pressure: 100-1000 kPa (1-10 bar).Only use new hoses for connecting the washing machine to the water supply. Used hoses must not be used anymore and should be discarded. Drain hose Connect the drain hose to the siphon or hook it over the edge of a sink with the “U” bend (see “Installation”/“Connect the water drain hose”). If the washing machine is connected to a built-in drainage system, ensure the latter is equipped with a vent to avoid simultaneous loading and draining of water (siphoning effect). Electrical connection Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and the current standard safety regulations. The technical data (voltage, power and fuses) are given on the rating plate on the rear of the washing machine. The washing machine must be connected exclusively by means of a socket with an earth connection in accordance with current regulations.